This set of files is quite like the original, except that I modified the device bracket to hold a Galaxy S5 with the flip-cover case Note that the phone holding section is very snug, which I like so the phone does not fall, but it does scratch my leather case a bit. If you want a loose fit, I would increase the depth and height of the top clips by 1mm or more. The bottom one are tight, but don't pull much due to the flexible nature of the leather flap. I put up the sketchup file up. There is a strange bug where the item that was imported from the STL (the "blank" I also published) won's stretch, I simply had to build on it. It does not affect the model, except that in sketchup you see a few extra lines. The holes take a 1/8th (3.18mm) bolt, but are quite tight, I recommend driving the bolt in and out 5 times in each piece before the first assembly.