V-Slot z-stage for Ultimaker Original This is a drop-in replacement for the z-stage to accommodate the MK3 Aluminium heated bed. Alternative parts to accommodate my original 3-point levelled heated bed set up (http://www.thingiverse.com/thing:84754) are also provided.Print all parts in ABS at 100% infill with 0.2mm layer. Print all V-Slot cross-section mating parts with the V ceiling pointing up to avoid supports. The support seats will have to be printed with support for the rail keys. Thumbwheels do not need any support for the nut cavity. Print the anti-twist caps holes facing down for strength. Parts referred to "old glass" are to accommodate my original heated bed set up (http://www.thingiverse.com/thing:84754). Mind you that you may have to unglue and reposition the washers receiving the ball magnets. Bill of Materials: 2x V-Slot 20x20 length:270mm 1x V-Slot 20x20 length:180mm 1x V-Slot 20x20 length:140mm 6x M5x15 flat head socket screws 4x M5x8 flat head socket screws 2x M5x10 flat head socket screws 1x M5x15 flat head socket screw 13x V-Slot slide in tee nuts (http://www.makerstore.com.au/product/slide-in-tee-nuts-25-pack/) 3x M3x30 socket head cap screws 6x M3 washers 1x M3x20 socket head cap screw 3x spring (original Ultimaker springs) 3x Ball magnets (7mm diameter) 2x M3x5 socket head cap screws 2x M3 nuts 1x M2x5 socket head cap screw 1x M2 nuts 2x M2 washers 3x M3x10 spacer nuts (normal nuts will do too) 2x V-Slot corner brackets 1 big bag to contain all the above (optional) For automagical assembly, place all components in the bag and shake! :))