Feeder for MasonStoneHenge Spring loaded extruder with PTFE support and pneumatic fitting for a M5 thread and for a 9.3mm thread like the one of the hot-end itself (untested). This is my first remix so it is maybe not perfect but it should do the job just fine. V1.4 Small design fixes. The 9.3mm version is untested yet. V1.3: Small hole now end directly at the end of the pneumatic fitting. The filament sometimes got stuck in the pocket that was left between the small hole and the large hole. Also the filament missed sometimes the entry of the fitting. That ends in chaos as the extruder motor tried to extrude but the filament was stucked, break and the rest parts was laying in this pocket, blocking the extruder and hard to clean. Should be fixed right now. Previous changes: V1.1: Hole diameter for the PTFE tube increased to match OD4. Hole for the pneumatic fitting slightly widened for easier mounting. I added V1.2 if you need a slightly more diameter for the tube (for example ABS printing and shrinking) but please try V1.1 first.Printer Brand: RepRapPrinter: OrmerodRafts: Doesn't MatterSupports: YesNotes: