I do some on-the-side python development at work and thought it would be fun to print a 3d python logo as a desk ornament. I started out using another project I found here on Thingiverse, but my printer wasn't printing the pin assembly correctly, so I decided to do my own remix and share it. The STLs are a little large. If printed at 100% the logo turns out to be about 150 mm x 150 mm x 20 mm and quite grand! The pictures were taken of a 50% print of the original STLs and turned out to be around 70 mm x 70 mm x 10 mm. (print time 30 min for each half 4 min for connector) I do not make any rights or ownership claims to this logo or python. I have used the logo SVG from the python group to make this thingi and to promote the language and programming community. Enjoy and print responsibly! NOTE: While the yellow and blue pieces might look similar, maybe even identical, they are not. For best results, print one top and one bottom. I printed top and bottom at 50% and connector at 49% and the fit is just about perfect. Depending on your printer and tolerances your mileage may vary. But a little touch-up with some sandpaper or glue and everything should fit like a glove!