This will be 3D printed near you and delivered to your door by May 05
Loading
These damn things break all the time, especially when they are as old as mine. This is for a D16 engine with the side dipstick by the timing cover. I believe this will fit the D16's 96 and up. I'm not sure with what the capabilities are of the typical printer so I added a couple different resolutions to try an accommodate. Any input about this is greatly appreciated!!
REVISION 2 DONE!!!! Stronger and short enough to clear the hood properly. Verified oil level is still correct with new handle (pin placement to handle stop dimension is held correctly) Happy printing ;)Remove and reuse old roll pin that is in the existing dipstick. I made the hole a little small so drilling my be required to get the pin to press in, I used drill bit #44 (.082")