Needed something that would fit in a tighter space and I liked this fpvgalaxy's design over most others. I reduced the width of it to 30mm. I also redesigned the wire clip due to the shape not printing adequately. Think I have completed this as much as I want to right now. Could use more tweaks here and there. but as this project sits it works great with fairly modest post print processing. IF YOU PRINT!!! I suggest that you print with at least a 70% infill. Especially the mounts! Currently printed in ABS!!! Suggest printing with NO rafts. You know your printer better than I, on mine though it prints more clean and with less after print processing! Update: Created a clip on mount for the machine side of the drag chain. Next will be the extruder side. Also changed the position of the clip. Reason the mechanics of the clip is more solid being printed on the side. The other way allowed the clip ends to break off easily. I used the original stl. as a guide and rebuilt the ends from scratch, spit in half and then mirrored.