Updated bed corners for 3mm thick glass bed for FlashForge Dreamer. I moved the holes for the screws because they weren't perfectly aligned to fit on the Dreamer bed. Also added a nut hole, for those who do not want to tamper with their bed, hence you will need two additional M3 nuts. Or you could use two M3 fine thread wingnuts instead. I must remind you that these corners don't put any pressure on the top of the glass, they only keep it in place. Additional requirements: 2 M3 nuts or 2 M3 fine thread wingnuts Installation is pretty simple. Just put the corners in place, tighten them down with the nuts and you're good to go.