Made this contraption to replace the feeders that comes originaly with the printer. They work alot better then the orginals but they are a work in progress and as such a beta version. Simpler to load the filament and better grip on the filament. Update : Added files for ver 1.1 Changelog : 1.0 Original design files 1.1 Added rounded corners, Curved the back so that the Cable hole have more clearance especualy for the right feeder is this important. Also added so that the washer isnt needed for the lever anymore and coned the inner block's lower 2 screw holes making it simpler to put in the screws without possibly cracking the outer Shell on the printer. Basecly more clearance. Now it is also possible to use all the original screws without replacing one of them :) Very special thx to Monza64 for comming with valuable sugestions for the design :)Rafts: Doesn't MatterSupports: YesResolution: 0,21Infill: 50%Notes: Need minor support for the screw holes.I printed them fairly strait up with 0,21mm and 50 % infill. Had to drill the screw holes a litle but no major thing so the screws went in simpler and wouldnt break the outer Shell of the printer. Update v1.0: Other then that you need to use the mechanical and screws from the original feeder exept for 1 of the screws that need to be replaced with a slightly longer screw. What you also need todo is to take apart the Wheel lever and remove the screw spacer closest to the screw head and reuse it on the screw that holds the lever arm in the piveting Point. Update v1.1: You need to take apart the Wheel lever and remove the screw spacer closest to the screw head.