Lid extension for the Flashforge DreamerPrinted at 0.2 layer height with 30% infill using PHA/PLA blend filament.
3mm plexi glass cut at 413mm X 140mm for the front and rear panels. 3mm X 264mm X 140mm for the side panels. I wanted to still be able to remove the plexi glass panels, what I did was install all the components including the plexi glass and lid. I then ran a bead of gel super glue on each of the corner posts and left it to dry overnight (complete assembly plexi glass and lid, as this keeps everything square and you can place a few books on the lid to weight it down).
I am now able to side out any of the panels in order to print PLA or for easy access to the extruder's I can slide out just the front panel. This does make the lid extension a permanent fixture, but I don't see myself wanting to remove it.