This is a five-cup kendama; having four cups atop the handle in a "plus" format. Note that typical 5-cup kendamas have the cups offset (due to the way the wood must be manufactured); this kendama has them all in the same plane. This is a remix of my "Kendama V2" — this thing only contains the new parts (two handle halves, and a connector bar). You must download the cups, tip and ball from http://www.thingiverse.com/thing:833183Print the top & bottom handle halves (they're different due to the angle of the hole for the string), and the "coupler bar". Then print two each of the "big cup" and "little cup" as well as one "tip" and "ball" from http://www.thingiverse.com/thing:833183. The string holes will probably need to be drilled out. When assembling the handle halves and coupler bar, make sure the string hole in the coupler bar is properly oriented to match the string holes in the handle halves.