This is a multi-bobbin holder for electromagnetic coils, with a large hole in the center to allow a magnet-filled pushrod to move freely. It also has slots for holding a larger tube to form part of the linear actuator. Object design in Autodesk Fusion 360 and downloadable at their [Gallery](https://fusion360.autodesk.com/projects/gluss-pusher-stator -v24). This is part of the Gluss Pusher project. Freely reusable under Creative Commons Share Alike V 4.0. (Note: This design does NOT have the bobbins correctly spaced at 1.5"s. This is a mistake, but probably anyone using it will want to change the geometry anyway.) Object design in Autodesk Fusion 360 and downloadable at their [Gallery](https://fusion360.autodesk.com/projects/gluss-pusher-stator -v24). Printed with MakerBot Replicator 2 using PLA on "fast" mode. Gcode produced by Simplify3D. Requires supports due to overhangs. Printed vertically to make sure central hole was dimensionally correct. Required a small amount of sanding of central hole. This could be useful as a starting point for someone making something different which requires holding two electromagnetic coils at precise distance. Probably would be better printed in ABS, to tolerate coils getting hot. As designed right now, it is too heavy. Could use special holders to help organize the wires from the coils.