Loved the original by Gattaca and have printed it several times scaled to different sizes as a test piece for our new printers. Pictures above is a print from the MendelMax 3 printer and the Minimax printer by Makers Tool Works The following are the Mods to the original. Added some material so the Engine could print properly in the center without center filled support. Increased the diameter of the leg struts. Rotated the Pods so the top rack holding tabs would print easier. Truss I added built in holding tabs in the corners as well as a base for the built in support at one end. I also cut this part in half so people with smaller printers should be able to print this model. I also scaled the truss so it fits inside the holding tabs a bit better. All parts are sized to fit even small print beds. Parts that require no support: legs thicker space_1999_eagle_body space_1999_eagle_cockpit Truss with print pads Landing gear Parts requiring support: pod left, auto support pod right, auto support engine, If your slicer has manual support add some right under the small lower round sections. Try to avoid auto support it will add support to the center which can be difficult to remove. It is possible to print this piece without support but it is not easy.