My first attempt at designing and making something for my Mendel Max 1.5 This is an iPad 3 and iPhone 4S combination stand with speaker amplifier for both the iPad and the iPhone. I have a dual charger connected to it so I can charge both of my gadgets at the same time. It'll fit iPhone 3, 3gs, 4, 4S, iPad 2 ( a bit loose thanks to comment from downeym), iPad3, and at least one model of the the iTouch. Any comments feel free. This is a large print and it barely fit on my 200mm x 200mm print bed. Set the skirt to print 2mm from the object and that should prevent the print from printing off the print bed. Print with support material for the bidges over the speaker outputs. On my Mendel Max 1.5, this print took approximately 10 hours using Slic3r and Pronterface (using Slic3r default settings from 30mm/s to 60mm/s with support material, fill density 0.2) . I used PLA (185C) on a heated bed (60C constant) sprayed with a light coat of Aquanet hairspray.
Dual iPad 3 and iPhone 4S charging stand with speaker amplifier.