I saw some beautiful designs of apple watch and iphone combo chargers so I set out to make one for a 360 and a phone. This was the first generation. I printed it but had to toss it at the airport, don't ask, so no pics of final. Anyway first gen had some issues, I used the board and coil for the watch charger from one of these. http://www.amazon.com/Wireless-Yootech%C2%AE-Charging-Blackberry-Qi-Enabled/dp/B00NWMI07S/ref=sr_1_2?s=wireless&ie=UTF8&qid=1440725976&sr=1-2&keywords=qi+charger Also stl's are in cm so if importing in mm scale by 10. Charger was okay but would keep 360 screen on and shut off charger so if the watch was on the charger too long would actually kill the battery. Another annoyance is that the 360 screen when charging is always horizontal, next design will charge watch in that direction. I ordered a single coil and a 3 coil qi from amazon and am planning a double wireless charger. http://www.amazon.com/Itian-Wireless-Charging-Single-Samsung/dp/B00V2HL4Y6/ref=sr_1_1?ie=UTF8&qid=1440725532&sr=8-1&keywords=diy+qi&pebp=1440725536581&perid=093R6D8254V9W6APR8ZK phone stand was designed for one plus one, generally phones with cases will not work, again since next one will be wireless should fix this. make sure to follow me to see the next versionAll parts can be printed without support except qi holder, this will need support could be printed in two directions, suggest top has hole for charger. Printed all parts with layer thickness of 0.2 mm. All parts should snap together, I would first place the coil and board into the holder, then snap the cover on. Next snap the arm to the holder. Slide the bottom on to the arm and phone stand to the bottom of the watch stand. run micro usb cables to desired points. I would suggest using a right angle micro usb with the watch portion.