Mount for fixing a surfboard with pointy tip onto the wall. PLEASE NOTE: that this is the first edition. The curvature for the nose is not that great, and the tail only works on boards like a fish-type. NOSEMOUNT: The sliding nose mount is quite nice and can be printed in 2 parts without support. The design prevents the mount from falling off/sliding off its wall mount, and the travel is about 5-7 cm. This allows for quick and easy removal of the board when its needed. The tolerances will also prevent the mount from sliding too easy, thus a little force is needed to lift it. This prevents the mount from sliding off by itself, but it can be slided up when its needed! All in all Im quite pleased with the sliding mechanism. Further work is to get the curvature better for the nose. TAILMOUNT: The Tailmoung can be printet in 1 part without support. It only works for fish-type boards, since it needs something to hold it in place. PRINTSETTINGS: I recommend 0.2 mm layer height and NO Support for all the parts. It might need to be rotated in your slicer software. I always use ABS for mounts and structural prints. ASSEMBLY: Simply snap the two nosemounts together. Screw the tailmount into the wall at the desired hight. Find the correct position for the nose mount when placing the board on the tailmount. Make sure the nosemount (assembled) is pressed all the way down onto the board. Make sure the mount can be slided up, and the board will be free. Install the nosemount onto the wall with screws aswell. If the interest is big i might be able to make several editions for different boards. Designed in SolidWorks. Please let me know if there is any comments/questions or if you would like the SolidWork Source files. Mail at: c.sigshoj ( a ) gmail . com (Spacing to awoid bots picking up my mail) for fast response. Enjoy ! ^-^