Originally finole had asked if this item was printable on a Replicator 2. I was pretty certain it was, even though I only have a TOM. I took the object, sliced it in half with NetFabb Studio, then created pin connectors for the two pieces. My supports are very well tuned and I can peel them off with my fingers, or help with a pair of tweezers for the more delicate parts. The larger the print, the more sturdy the detailed parts are, and the easier the supports come off. I suspect an even better print from a larger format printer than my TOM.Printed with full exterior supports. 10% infill, 2 extra shells. Carefully remove the support structure with a pair of tweezers followed by a slight sanding with a needle file.