Yes! Finally, a fan bracket for the 3uP which provides cooling to the print with NO LOSS OF PRINT AREA (actually you may possibly lose a tiny square in the front right corner...but close enough!) As I've said before, I would not be making a fan bracket if it meant a loss of print area, but I have finally found a way to work one in, and it works great.Required Materials 4x M3x20mm Bolts 4x M3 Hex Nuts 1x 40mm 12V Fan This will only work with my custom e3d extruder and the e3d v6 hot end. Use this fan bracket with other setups at your own risk. Print both parts, sandwich the fan in the middle, then bolt the parts together. Be sure to insert the bolts through the duct side first, so that the hex nuts will be the part facing up once the bracket is assembled. Mount it to the bottom right bolt hole on the extruder, using the longer 45mm bolts. note In the images, I only had 25mm bolts on hand. Using 20mm bolts will make it look much cleaner and it will allow you to use bolts in all 4 holes instead of just the bottom 2.