This is a drop-in replacement for the Subaru BRZ/Scion FRS cupholder with an enlarged phone pocket sized to fit a Nexus 6. It also includes a cutout for a single coil Qi charger. Note that the phone pocket is DEEP it nearly swallows my Nexus 6, which is a huge "phone." I had to do this to get the charge coil to line up with the receiver coil in my phone. Just print, glue your qi coil in, and attach the top via the screw hole in the middle, or you could just glue it all together. I wanted to be able to take it apart in case the coil went bad or something. To print the top, you'll need support structure because of the lip. I also used a raft because of the small surface area actually touching the bed. There is a hole in the bottom of each cup, these are to run a couple of small wires for some edge lit acrylic or something. I haven't decided. I also attached to source files (.ipt). These are Autodesk Inventor 2015 files. Be forewarned, though, I'm not very good at workflow, so expect the part to break if you try to modify it too much.