A revision of the Sidecar Controller Housing for Beta Smoothieboard Taller & deeper to accomodate the larger footprint of the 5XC Kickstarter version of the Smoothieboard. Approx.222mm Tall x 104mm Wide x 134mm Deep Houses: 5XC Smoothieboard (oriented long dim. vertically) ReprapDiscount GLCD Diablotek PHD Series PHD380M 380W MicroAtx PS. Holes for the power switch, printer harness, usb cable are omitted from these models and left for the individual to define. This is a design of my own creation. Hasn't been printed by me. but it's not much different from the original. The 4 spacers that are part of the top cover stl are for placement between the glcd circuit cards. A couple of pieces of music wire are used to pin the hinges together. Bond (superglue) the pins into the door. It will likely be necessary to drill out the holes in the hinges as they tend to close up during printing. The information on how to connect the GLCD to the Smoothieboard can be found at http://smoothieware.org/panel#toc3