Based on:http://www.thingiverse.com/thing:275352 Need: 1x 7/16" head bolt, 1.5" long 1x toilet bolt, at least 2.5" long (seen on picture) 2x 7/16" nuts. Print settings: I printed "Pivot-base.stl" at a 45 degree angle, with support. "Bottom2.stl": I flipped at 180 degrees with support. I will hesitate to make the above print recommendations because they may not print correctly with your hardware. I really didn't pay much attention to printing limitations while designing, sorry. This case is currently mounted on my t-slot aluminum frame.