OpenForge and DwarvenForge are awesome, but what if you want to make a multi-level dungeon? This cylinder is exactly the right height to stack OpenForge and DwarvenForge tiles on. Each cylinder also features 4 tabs at the bottom. Print the included clip file and slide it over the tabs to hold the cylinders together. I designed the clips and tabs to fit a little loosely, so you have some play when trying to align several cylinders at once. The cylinder is about 2"/5cm high and 1.4"/36mm wide not counting the clips; with the clips it's 1.8"/46mm wide. The clips are 0.36"/9mm by 0.27"/7mm by 0.43"/11mm. Both pieces print without support or raft. Thanks to my Patreon supporters for their pledges, which made these pieces possible.Printed without support or raft, on a Printrbot Simple 2014.