EXPERIMENTAL! I have not printed this yet and don't have access to my printer at the moment. Case for the New Proto X Nano quadcopter since it didn't come with one. Put it in this case and toss it in your bag keeping your blades safe from breaking. Take it with you everywhere! http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXDVYH I figured the controller was robust enough to not need to be a part of it. Plus it would be a huge print with it. Everyone needs to get one of these! Print the bottom and the top. The snaps should have enough play to hold and to not break. Let me know if alterations are needed. To hold the quadcopter in place either use an elastic band across the 4 holds. or glue an adequate sized piece of foam to the lid to hold it down. I didn't want to use snaps on the PCB of the vehicle because I feel they would hurt it or just break off.