A collection of parts I have designed for my ZMR250 + Sparky 2 quadcopterA small mount I have made for the KISS BDB + RCTimer/Kiss mini ESC. ESC - http://www.rctimer.com/product-1280.html PDB from James - the creator of the Sparky and Sparky 2 controller https://github.com/TauLabs/TauLabs/wiki/Sparky2 https://github.com/peabody124/misc_hardware/wiki/Kiss-PDB Combined Xt60 and Cornlight mont (rear) http://www.banggood.com/Blue-SKY-QAV250-3_9g-XT60-Installtion-Connecter-p-962146.html http://hobbyking.com/hobbyking/store/__26411__LED_Corn_Light_12V_0_4W_2_LED_Blue_2pcs_.html?strSearch=corn If you do not want to include XT60 and cornlight, you can use these spacers/LED mounts: http://www.thingiverse.com/thing:473966 Front mount for two cornlight 4mm spacers (2 on each side of the arms - mounted with the spacer holes closest to the center of the arm - to make space for the motor wires + the needed space for the mini ESC`s I have included two images to show how to use the arm spacers. Antenna tube (3,2mm) mount for RX antennas Flexible antenna mount for the 433Mhz antenna - can be used with other antennas. I have used a M3 rubber vibration mount for this. XT60 mount without Cornlight mounts Front FPV camera + FPV TX (200 mW mini). This is V1 designed for the Sony 25x25 mini CCD camera with plastic housing - you have to do some sanding on the camera housing to make the tilt work + cut the front of the ZMR LiPo plate. The ZMR frame I used for my mods: https://grabcad.com/library/zmr250-quadcopter-frame-1 A big THANK YOU to Arkon for sharing the files.