Banana Stand ==== There's always money in this banana stand! This banana stand includes a handy coin slot to so that there is always money in it. Works equally well with both left- and right-handed bananas. The coin slot holds about tree fiddy.I printed this using a somewhat translucent yellow PLA. The banana model includes built-in support for the top of the coin slot. This gives you the option of either cutting it out after printing to use as a bank, or you could even drop some coins in the slot while it is printing to ensure that there is always money in your banana stand. The slot in the banana and the slot in the base that holds the banana upright make for a lot of bridges in this print; your temperatures, speeds, and fans should be well-calibrated if you want good results. You should be able to fit both of these on a standard 200x200mm plate. Designed in SketchUp, sliced with Slic3r using these settings: ; generated by Slic3r 0.9.8 on 2013-05-23 at 19:08:15 ; layer_height = 0.2 ; perimeters = 3 ; top_solid_layers = 3 ; bottom_solid_layers = 3 ; fill_density = .15 ; perimeter_speed = 30 ; infill_speed = 60 ; travel_speed = 130 ; scale = 1 ; nozzle_diameter = 0.35 ; filament_diameter = 2.9718 ; extrusion_multiplier = 1 ; perimeters extrusion width = 0.52mm ; infill extrusion width = 0.52mm ; first layer extrusion width = 0.70mm