This is a simple clamp for holding bundles of wires, cables, or even pneumatic hose. Edit: Here is a modified version by 'robkingva' which allows you to snap the parts together! http://www.thingiverse.com/thing:715328I printed in abs at 20% rectilinear infill but I set every 5th layer to print solid for added rigidity. Be aware that one of the parts is oriented upside down in the model, so if you print it as provided then you are trying to make a cantilever over air. Just remember to flip the part! Hardware Required: (1) #8 x .75" long bolt (1) #8 nylock nut OR You could probably substitute a Zip-tie for the bolt