This little chameleon clips onto your monitor, laptop screen, pencil, printer, mouse cord -- or just about anywhere else (as shown here, perched atop of http://www.thingiverse.com/thing:19104).2016/1/25 Update: A new "V3" version with stronger limbs, built-in support and repaired geometry has been added. If you had difficulty removing supports without breaking the front legs on the other version, try this one! Print with 4 shells for strength.Supports are included for easy printing. Use a heat gun to customize this DeskPal's paws to perfectly fit your favorite pencil or other perch. The default size grabs a mouse cord perfectly. The prints shown here were printed on a Makerbot Replicator 2 in white and glow-in-the-dark green PLA at 100% and 120% size, respectively. 2016/1/25 Update: A version with improved support and repaired geometry has been added.Prints beautifully in less than an hour with 25% infill, 4 shells, and 0.22 mm layer height on a Makerbot Replicator 2.