Simple two part stand for holding a phone in landscape view. Needed a stand to do some "steady" time lapse and slow-mo shots with my phone.Used OpenSCAD to do the models at the same time. Went through two design revisions before getting something I liked and could print with a Thing-O-Matic. Rafting is highly recommended. You will only need to change two clearly marked variables in the OpenSCAD model to make a stand that will fit your phone: size: diameter of ball (in mm) widthOfSlot: how thick your phone is in mm (give +1mm for a nice fit) After printing you may need to trim a side of the inner ball joint to complete the assembly.