Started from an existing RaspberryPi enclosure and modified it to be able to contain as well the Adafruit PiTFT Mini Kit (http://www.adafruit.com/products/1601). It may be a bit hard to close, but it stays tight in place afterward. Also you can print the Support (you'll need two of them), to hold the case at a comfy 30 degrees.I printed mine on a Makerbot Replicator 2 on low res with default settings. No need for support neither rafts while printing. You can optionally print 2 of the Support (separate file) to keep the Enclosure standing at a comfy 30 degrees.