This is the STL files for a: Cubietruck Cubieboard3 Cortex-A7 Dual-Core 2GB RAM/8GB Flash with Wifi + BT and 2.5" SATA hard-drive This model works best when you use bottom standoffs on one layer of the plexiglass sheets that they send with the board. Put this plexiglass layer underneath the board and the bottom stand-offs fit into the holes. Your 2.5" SATA drive will fit underneath the plexiglass with room for the cables to go up one side. Note: shorter standoffs into cubietruck board -> plexiglass sheet -> longer standoffs -> holes in base plate (Sata drive under plexiglass)Used calipers and multiple passes to get all the ports correctly sized and a nice tight fit to hold both the board and the disk drive securely. When printing turn on "Raft" so you can remove it and also not have it pop off the build plate on a corner. The lid in the picture was printed at low-res, I have done variants of it with slots for cooling