As we created lots of wands recently - you can look at those here - we decided to create a nice display to hold and show them. This model is the result of this decision. You can check out how we did it here.You need to print the top and bottom part + 8 pieces of the pillar (which is a half pillar actually). Then you can glue the four pairs of the pillars together to get the four pillars. Now you need four short piece of 3mm filament: this will be used as a helping material to glue the pillars to the top and bottom parts. It could happen you need to drill the holes a little bit to get a perfect fit for the filament pieces.