Needed a protective case for my Flip32 (from Witespyquad) and couldn't find one here...so I made one! This is for the right angle pin version.I like to print this with supports so the screw holes on the top lid will be nice and flat. You might need to slightly sand the columns depending on how snug you want it to slide in. Also, I like to clean up all the holes with a 2.5mm drill for the bottom and a 3mm drill for the top case. I used M3 16mm pan head screws for the top. The bottom piece can either be mounted by tape or velcro, or optionally use the 4 mounting holes with shorter M3 screws to attach it to the quad.