Want some freshly squeezed orange juice or do you want some lime in your favorite soda drink? Use this citrus juicer to make your drink! You can screw this juicer on top of almost any bottle and when you squeeze your orange the juice flows right in the bottle. The holes where it has to go through make sure no pulp will ruin your drink. You then have your fresh orange juice directly in the bottle. The prints are test fitted on bottles from the following countries:Please leave a comment, make or personal message when you printed the juicer and let others know if it fits on the bottles used in your country! (I think it fits almost every bottle)(13-Mar-2015 ) UPDATE: There is now also a version with bigger holes available for download. Now you can also enjoy your drinks with pulp.Rafts: Doesn't MatterDoesn't MatterSupports: NoNoResolution: .25.25Infill: 25% honeycomb25% honeycombNotes: I printed this using the following settings: Pla plastic 0.25 mm layer height 190 degrees Celsius extruder 50 degrees Celsius print bed 3 shells (make sure you use enough shells so the juicer is completely watertight) 25% infill (honeycomb) 30 mm/s perimeter speed 50 mm/s infill speed 5 mm brim no support material I recommend using more shells to make sure the thing is completely watertight INSPECT YOUR PRINT WHEN IT IS DONE! It could happen that some strings are formed. Make sure your print is completely clean, because you don't want to ruin your drink with plastic parts. MAKE SURE YOUR PLASTIC IS SAFE TO USE WITH FOOD AND DRINKS.