Very new to 3d printing and this will make my fourth or fifth print apart from very small things. Looking at it, many of you experienced folk are probably shaking your heads but I figure I'm not going to learn unless I jump in and start screwing around. Anyway, I didn't make the 3d model. I found it here http://sketchup.google.com/3dwarehouse/details?mid=6250854ecf2b954269095ca863cece2f&prevstart=0 when I went searching for a Mobius strip to print. This is more interesting than a basic strip and seemed like a good challenge. I just plugged in into Makerware since it's all I understand how to use at the moment. Printed with rafts and supports and whatever default options there were like 2 shells and stuff. 1h40m to print and another hour to deal with supports and it's done. A little thin in places and supports were pretty awful to remove, but still possible.