Minimal case for the NVIDIA Jetson TK1 development board. Very basic...a top and bottom piece supported by standoffs & hardware...it keeps fingers and dropped tools off the board on one's desk, doesn't accommodate drives or add-ons. Yeah, this would look great in NVIDIA green, but I only had orange acrylic handy at the moment. :) (Update: I've taken to calling this style a "sneeze guard," after the restaurant industry's name for protective food-windows.)Laser cut from 1/8" (3mm) acrylic. Requires four 3/4" threaded standoffs (4-40 thread) and eight 1/2" screws. Can use 1" standoffs in a pinch, it'll just be taller. I'm using Digi-Key part 3481K-ND. REMOVE RUBBER FEET (if attached) FROM YOUR TK1 BOARD before assembling. Peel carefully and you can re-stick them under this case. Four spacers (the small rings in the fan cutout) install between the board and base piece.