Following on from the success of the Nested Birdhouse (http://www.thingiverse.com/thing:116288), I thought I would push the nested small footprint concept a little further, with a printable case. Use it as a lunchbox, purse, briefcase, clutch bag, backpack, fashion accessory etc, you decide. http://youtu.be/vWCLyMZZcQE http://www.gyrobot.co.uk http://www.facebook.com/gyrobotukPrint 2 off without support, it's all in the geometry. Attach the two halves with cable ties or PLA rivets. The hole in the catch is for the addition of a lock, carabiner or bolt etc. You can also attach a shoulder strap to the handle or carabiner. Scale up or down (clearance disclaimer) to suit : Print cube size for a single half 100 x 105 x 96 Print cube size for two halves (nested) 143 x 130 x 96