Well after about 10 flights with my Gemini racer the stock board camera died. I had a DX-201 on the shelf and since it is such an awesome camera I thought I would design a mount for it to fit in the Gemini. It was quite a challenge but I got it to fit, and all canopies and stock electronics remain unaffected by this new mount. And you can still hang the Mobius from it too, in exactly the same way the stock mount does it. It is a drop in replacement for the Gemini stock mount. Only thing you'll need besides this thing is a DX-201, it's cable and 2x 2mm x 6mm long screws. Otherwise uses the stock hardware to mount to the frame. Update 2-17-15: I revised the "whole" version. It was supposed to have chamfers where the sides of the DX-201 lens housing meets the printed part.The whole version is for those who don't mind using supports, or have a hips capable printer. If you hate supports, you can try the split version, which will require gluing the parts together post assembly. Either approach works well. Use 100% infill and two shells. You will have to clean up the small holes with a 2mm drill post print. This mount works great, you won't have to change the location of any of the stock electronics. The only change is the lens will poke out the front of the canopy about 4mm. Looks great though! IMPORTANT As with all of my things, these models are scaled up 1.019 in the x and y axis to allow for ABS shrinkage on my printer. You may need to invert this scale or change it depending on your printer and material choices.