I made this with Micronauts in mind, but it could be used for Joes or Star Wars figures as well as a whole host of other 1/18th scale figures.This part was made with Tinkercad. Edit the part online at: https://tinkercad.com/p/acc0761039ad42ab/72Share and Enjoy!This still needs some tweaks. I have printed several different changes, but more are needed. Print it out, stick the long stick in the center of the stand and place the bracket that holds the figure over the other end, slide it into place for best height. Cutting the peg down may be necessary as well as a little sanding if it is too tight, or gluing if it is too loose.