I couldn't find any of the existing feet for the Rep1 that I liked so I made my own! :) This thing adds adjustable feet for the Makerbot Rep1 printers. It uses 10mm bolts and nuts for the risers. The feet in the photos were made using left over adjustable feet from a wire rack. You know, the ones with the plastic wedge thingies that never stay put without a mallet and a few choice words of encouragement. That, of course, after you discover one corner is one notch lower or higher than the rest. Bah! Ingredients: (4) 10mm x 25mm (or 30mm) bolts (4) 10mm nuts Instructions: Presto! No more wobbly 'bot. :) Note: if you want to use a different bolt, see the .scad file.