This is a printable extruder plate for the ultimaker.I really like Jelle's 4 extruder plate, but the local hackspaces do not have a laser capable of cutting the 6mm plywood.This solves my problem of where to put the second extruder. I made it a tiny bit wider that the laser cut ones so they will fit a printed extruder.This sits on top of the far right bearing cap. You will also need to drill 2 holes in the back of your ultimaker.bom: 4 20mm x 3mm screws 2 3mm nuts 2 * 3mm washerscura slicing settings:0.2 layers .6 wall & top/bottom thicknessI printed this with 30% hexagonal IMPLA from Diamond age. Other wise i would use 60%