This model is the enclosure for Gineer R&D's CremaBot. CremaBot is a project where a Standard Jura Impressa XF50 Classic coffee machine was converted to be an IoT device, allowing the machine to be controlled from the web. The cut-outs in the top half of the case line up exactly with the CremaBot v2.2.0.7 circuit board to allow for the interface cables to and from the Jura Coffee machine, the end stops and the external power to be routed through. The last cut-out fits a 4 pin header directly onto the stepper motor driver if this is fitted. Check out the full project at: http://gineer.co.za/Projects/CremaBot https://youtu.be/qJ30F3_xPHo I printed the model in two parts with no support material required. Using a soldering iron I heated and sunk four M3 metal nuts for hex screws to turn into holding the two parts securely together.