This two piece device allows you to get a firm hold on any type of textile without puncturing them. The first part of the device, which we will call the lock (shown in blue), fits closely into the base, which we will call the star because of its resemblance to a ninja throwing star (shown in red). This device has numerous useful applications around the home no matter where you live. The project webpage is here To Make: The STL files for printing both the star and the lock are available here and can be printed out of various materials on an open source rapid prototyper like the RepRap. To Use:Turn the lock piece 90 degrees and pull into place (as shown assembled in Figure 1). Both the lock and the star have multiple holes that can be used either with tie lines or nails depending on your application.Suggestions for improvement always welcome.