This will be 3D printed near you and delivered to your door by May 06
Loading
I chopped him in half, printed it and stuck him back together!It's printed with Faberdashery PRINCELY PURPLE and MELLOW YELLOW because everyone needs a Purple and yellow dinosaur in their life!
http://www.faberdashery.co.uk/products-page/print-materials/princely-purple/
http://www.faberdashery.co.uk/products-page/print-materials/mellow-yellow/Thanks to Hurtzmyhead for a great low-poly model, it looks really Fab!This was printed without any support material at 60mm/sec print speed
0.5mm nozzle and 0.3mm layerChopped in half and scaled with Netfabb and Sliced with SF41.He is 1.5 X bigger than the original as a weedy dino is not as much fun. When printing the Bottom half the back fins will sag as they are not supported, he looks ok, so give it a try.