Thunderbird 2 Made with Green, Yellow, Red, White, Black, Silver & Natural PLA From the TV series by Gerry AndersonI used the Standard profile to print on a Replicator2 Part Name Plastic used Print time Green- Front 48g 3.0 hrs Green- Rear 23g 1.5 hrs Green- center 86g 5.25 hrs Green- Tailplane 17g 1.5 hrs Green- wings 8g 45 min Yellow- front_center partition 13g 30 min yellow- engine front section 5g 20 min Yellow- engine ring 4g 10 min Black- Bottom rollers 3g 8 min Black- Engine inlet 1g 5 min Black- Rear engine insert 2g 5 min Black- Tailplane center front inserts 3g 10 min Black- rear engine section 5g 20 min Black- Tailplane end inserts 1g 5 min White- Figures 5g 15 min Red- Engine_tail 13g 55 min Grey- Engine baffle 2g 5 min Transparent- Windows 2g 8 min How to get yellow stripes on the wings using Green and yellow PLA. This tip assumes you are printing 1 set of Green- Wings with rafts enabled. Start the print using Green PLA At 77% complete Change filament to Yellow At 82% Change to Green At 86% Change to Yellow At 92% Change back to Green to finish the print