This is a small case I made for the the GPS receiver base on a Ublox NEO-6M, as shipped by Unmanned Tech in the UK. Update 11/08/2014: Added a bit more space around the parts to allow for slight over-printing problems stopping the lid from attaching. Added an option to create four holes in the base to allow for fixing to a quad. There is now also a configurable parameter tolerance, which is a distance that will be added between the lid and the base, and between the base and the PCB. The default is set pretty tight. The latest snapshot is available on GitHub.This is a small case I made for the the GPS receiver base on a Ublox NEO-6M, as shipped by Unmanned Tech in the UK. Update 11/08/2014: Added a bit more space around the parts to allow for slight over-printing problems stopping the lid from attaching. Added an option to create four holes in the base to allow for fixing to a quad. There is now also a configurable parameter tolerance, which is a distance that will be added between the lid and the base, and between the base and the PCB. The default is set pretty tight. The latest snapshot is available on GitHub. Print out the two parts that comprise the base and the lid. The defaults should be fine for a v2 GPS module, although the tolerances are set very tight. Either using the Configurator here, or by editing the scad file, you can easily change the following settings: