A very basic roll holder for Aluminum foil, parchment, cling wrap, etc. Basically print two Roller Spindle brackets, one Guide Track, and one Cutter, mount the spindles and the guide to the inside of the cabinet using #6 hardware, mount a standard exact-o knife blade to the cutter (you'll need to drill a small hole in the cutter) with the blade inside one of the slots in the cutter, and then slide the cutter onto the track. Note, you can print as many spindles as needed and reuse the same cutter. Open a box and put the roll onto the spindles. When you want some aluminum foil or plastic wrap just pull down, slide it into the guide, pull out the amount you want, and then slide the cutter across to cut to size while holding the sheet taught. Warning the exact-o blade is exposed when cutting so take precautions. When not in use slide the cutter all the way over until the blade is in the knife cover.