Most times when I printed the original noisemaker on my Up 3D Printer it would create a support inside the small gap where the clicker goes. This was extremely hard to clear out especially when I reduced the size of the Noisemaker for samples. So here I have downloaded the Noisemaker's Body, remodelled (via SketchUp), cut in half for easier assembling and minimal support removal. A simple dab of Craft Glue (I have found this glue better than super-glue) to bind the two of the sections together, after placing the clicker in place, works a treat.Print two pieces of the Noisemaker Body-Half. Place Clicker into place. Glue the two parts together. Assemble gear and handle.