Laser cut enclosure for a Meanwell SE-600 series power supply. Made to replace the stock Rigidbot power supply. Reuses the Rigidbot output power cable, and adds a on/off switch and uses a standard IEC-14 power cable. Material is .22" Acrylic, printable on a single 18x24" sheet. Changes will need to be made to the profile cutouts for thicker/thinner material. I purchased the sheet from Lowes: http://www.lowes.com/pd_239981-1638-1AG2123A_0__ It uses 8 M3 socket cap screws - http://www.homedepot.com/p/Crown-Bolt-M3-0-5-x-8-mm-Zinc-Plated-Plain-Metric-Socket-Cap-Screw-3-Piece-per-Bag-803178/204808022?N=5yc1vZc2b0Z1z0sfzwZ1z0ygcx The holes are sized to pass through to the casing. And two #6-32 3/8" flat head machine screws to fasten the switch and plug. These two holes are sized to be tapped for #6-32 screws. http://www.homedepot.com/p/Unbranded-6-32-x-3-8-in-Phillips-Flat-Head-Machine-Screws-8-Pack-28301/202706117 And using a screw mount C14 plug switch which is dimensionally compatible with http://www.schurterinc.com/var/schurter/storage/ilcatalogue/files/document/datasheet/en/pdf/typ_DC11.pdf