This is a tilt adapter for the popular ZMR250 miniquad and FatShark 600TVL camera, but basically any camera with 12 mm lens thread should work. The camera sits behind the tilt adapter and when you screw a lens through the printed part, it will all hold together making a really simple and lightweight tilt solution. Tilt part is available as 10, 15 and 20 degree variants. Printed in two parts. Rotate parts as required. Angle modules are not in optimal print orientation. Attach together with CA glue or acetone if printed from ABS. The multirotor I am using is built with RCTimer 1806 2300kv motors, Sunrise Slim OPTO 20A BLHeli ESCs, the awesome OpenPilot CC3D flight controller and 850mAh 6S battery.