I am now calling this project complete. If there is anything else that you would like me to add to this please feel free to message me. Very complex customizable pendant with up to 432 outer rings and up to 43,200 inner rings. Getting this item exactly where you want it to be will be a long trial. I recommend getting a feel for it on the integrated customizer and then doing any serious setup within an Openscad editer. Please see below for a few tips for this item in Customizer. Apologies in advance for a 840 line script just for a pendant. When using Customizer remember a few key things. 1.Move slowly!!!! This is an epicly large document and the Customizer is not streamlined enough to truly handle it. 2.Inner rings can only show inside of Outer rings. If for some reason your inner ring settings tell it to be outside of its outer ring it simply wont show.(You can however move an inner ring outside of an outer ring enough to only show small arcs of it!) 3.When creating a new Customized version of this item work with one outer ring at a time. Finish that ring before you add another. Each outer ring adds a huge amount of computations. 4.Take your time getting the feel for this while only using one outer ring. Moving between outer rings for full on custumizing can be very confusing. 5.You cannot not "twist" outer ring one. You would missalign the pendant loop.