This box attaches to the left side of an Epilog Zing 6030 Lasercutter. It provides protection for the exhaust outlets, by tunneling the air to the front and back, as well as storage for documents, rulers and other things.It only covers the rear half of the Lasercutter's left side. Watch out for the front box design, which will be much more sophisticated.The design was made with 4mm thick wood in mind and fits on 6 DIN A3 (420x297 mm) plates. I personally used wood for the outer walls and the floor (located above the exhaust vents) and cardboard for the divider walls inside.The Box dimensions are: width: 282.7mm, height: 397.5mm, depth: 150mm + 11mm (for hooks attaching to exhaust outlets). See the pictures for the attaching mechanism.There are four storage compartments: two for rulers and "long things" (should be longer then 30cm, otherwise they disappear) and two for DIN A4 documents.